Skip to content
  • Close-up of a Victron Battery Protect 100A - 48V device, showcasing its 48V capability, connection points, and green terminal blocks suitable for 100A.

Victron Battery Protect 100A – 48V

£164.44 £125.70 Save 24%

The Victron BatteryProtect is designed to protect a leisure battery in an electrical system. It disconnects the battery from non-essential loads before it is completely discharged, which would damage the battery. The BatteryProtect is not designed for reverse currents from charging sources.

  • Suitable for loads up to 100A
  • Suitable for 48V systems
  • Non-smart model

Sorry, this product is not available to purchase in your country.

SKU: BPR048100400 Categories: ,

One percent of this purchase goes to planting trees and advancing access to solar energy 🌱
Find out more

Campervan electrics leaving you confused?

Our team of engineers will design your perfect system, bespoke to your needs 👌
Discover more It's free

    The BatteryProtect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.

    The BatteryProtect is not designed for reverse currents from charging sources.

    Features

    Programming made easy

    The BatteryProtect can be set to engage / disengage at several different voltages.

    The seven segment display will indicate which setting has been chosen.

    A special setting for Li-ion batteries

    In this mode the BatteryProtect can be controlled by the VE.Bus BMS.

    Ultra low current consumption

    This is important in case of Li-ion batteries, especially after low voltage shutdown. Please see our Li-ion battery datasheet and the VE.Bus BMS manual for more information.

    Over voltage protection

    To prevent damage to sensitive loads due to over voltage, the load is disconnected whenever the DC voltage exceeds 56V.

    Ignition proof

    No relays but MOSFET switches, and therefore no sparks.

    Delayed alarm output

    The alarm output is activated if the battery voltage drops below the preset disconnect level during more than 12 seconds. Starting the engine will therefore not activate the alarm. The alarm output is a short circuit proof open collector output to the negative (minus) rail, max. current 50 mA. The alarm output is typically used to activate a buzzer, LED or relay.

    Delayed load disconnect and delayed reconnect

    The load will be disconnected 90 seconds after the alarm has been activated. If the battery voltage increases again to the connect threshold within this time period (after the engine has been started for example), the load will not be disconnected.

    The load will be reconnected 30 seconds after the battery voltage has increased to more than the preset reconnect voltage.
    Product SKU: BPR048100400


    Weight 0.8 kg
    Dimensions 6.2 × 12.3 × 12 cm
    Brand

    Victron Energy

    Manufacturer Part Number

    BPR048100400

    Voltage

    48V

    Current (A)

    100

    Peak Current (During 30 Seconds)

    250A

    Operating Voltage Range

    24 –64V

    Alarm Output Delay

    12 seconds

    Max. Load on Alarm Output

    50 mA

    Load Disconnect Delay

    90 seconds

    Load Reconnect Delay

    30 seconds

    Protection Category

    Electronics: IP67 (potted), Connections: IP00

    Connection

    M8

    Mounting Torque

    9 Nm

    Bluetooth Enabled

    No

    Smart functionality

    Non-smart

    Warranty

    5 Years

    Product or kit

    Product


    Reviews

    There are no reviews yet

    Be the first to review “Victron Battery Protect 100A – 48V”

    Your email address will not be published. Required fields are marked *

    Overall rating*
    0/5
    * Rating is required
    Rating:*
    0/5
    * Rating is required