Skip to content
  • Black Victron Cyrix-Li-charge 24/48V 120A Intelligent Charge Relay by Victron Energy with two terminals and 24/48V 120A labeling on the front.

Victron Cyrix-Li-charge 24/48V 120A Intelligent Charge Relay

£93.96 £79.34 Save 16%

The Cyrix-Li-Charge will connect a battery charger with 3 seconds delay: – if the Charge Disconnect output of the VE.Bus BMS is high, and – if it senses 13.7V (resp. 27.4V or 54.8V) or more on its battery charger connection terminal, and – if it senses 2V or more on its battery terminal (the Cyrix will remain open, if not connect to the battery).

  • 120A charging current
  • Suitable for 24V and 48V systems
  • Suitable for use with lithium batteries

Sorry, this product is not available to purchase in your country.

SKU: CYR020120430 Categories: ,

One percent of this purchase goes to planting trees and advancing access to solar energy 🌱
Find out more

Campervan electrics leaving you confused?

Our team of engineers will design your perfect system, bespoke to your needs 👌
Discover more It's free

    The Cyrix-Li-Charge will connect a battery charger with 3 seconds delay: – if the Charge Disconnect output of the VE.Bus BMS is high, and – if it senses 13,7V (resp. 27,4V or 54,8V) or more on its battery charger connection terminal, and – if it senses 2V or more on its battery terminal (the Cyrix will remain open, if not connect to the battery).

    The Cyrix-Li-Charge will disengage immediately whenever its control input becomes free floating, signalling cell over voltage or cell over temperature.

    In general a cell over voltage alarm will reset shortly after charging has been stopped. The Cyrix will then reconnect the charger after a delay of 3 seconds. After two attempts to reengage with 3 seconds delay, the delay increases to 10 minutes.

    Whenever battery voltage is less than 13,5V (resp. 27V or 54V), the Cyrix will disengage with a delay of 1 hour. Note 1: In case of zero discharge current, or a small discharge current, the Cyrix will not disengage shortly after the charger has been switched off and/or disconnected, because battery voltage will remain higher than 13,5V. Note 2: If, after the Cyrix has disengaged, the output of the battery charger immediately increases to 13,7V or more, the Cyrix will re-engage, with 3 seconds delay

    Product SKU: CYR020120430


    Weight 0.11 kg
    Dimensions 4.6 × 4.6 × 8 cm
    Brand

    Victron Energy

    Manufacturer Part Number

    CYR020120430

    Continuous current & Breaking capacity at 12V or 24V

    120A

    Current Consumption When Open

    4 mA

    Protection Category

    IP54

    Warranty

    5 Years

    Country of Manufacture

    Malaysia

    Voltage

    24V, 48V

    Current (A)

    120

    Product or kit

    Product


    Reviews

    There are no reviews yet

    Be the first to review “Victron Cyrix-Li-charge 24/48V 120A Intelligent Charge Relay”

    Your email address will not be published. Required fields are marked *

    Overall rating*
    0/5
    * Rating is required
    Rating:*
    0/5
    * Rating is required